Samsung DV431AEP/XAC Uživatelský manuál stáhnout pdf

CLOTHES DRYER

Technical Information

CAUTION

All safety information must be followed as provided in Service Manual of DV431, DV231.

WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power to dryer

before servicing, unless testing requires power.

Code No. : DC68-02365D-03

IMPORTANT SAFETY NOTICE – “For Technicians only” This service data sheet is intended for

use by persons having electrical, electronic, and mechanical experience and knowledge at a level

generally considered acceptable in the appliance repair trade. Any attempt to repair a major

appliance may result in personal injury and property damage. The manufacturer or seller cannot

be responsible, nor assume any liability for injury or damage of any kind arising from the use of

this data sheet.

• Due to possibility of personal injury or property damage, always contact an authorized

technician for servicing or repair of this unit.

• Refer to Service Manual (DV431, DV231) for detailed installation, operating, testing,

troubleshooting, and disassembly instructions.

(Technical)DV431AEP-02365D-03_EN.indd 1 2012-04-26 �� 10:42:54

1 2 3 4 5 6 ... 11 12

Shrnutí obsahu

Strany 1 - CLOTHES DRYER

1CLOTHES DRYERTechnical InformationCAUTIONAll safety information must be followed as provided in Service Manual of DV431, DV231.WARNINGTo avoid risk o

Strany 2 - ALIGNMENT AND ADJUSTMENTS

10TROUBLE SHOOTINGWARNINGTo avoid risk of electrical shock, personal injury or death; disconnect power to dryer before servicing, unless testing requi

Strany 3

113-WIRE system connectionsA. External ground connectorB. Neutral grounding wire (green/yellow)C. Center silver-colored terminal block screwD. Neu

Strany 4

12WIRING DIAGRAMWIRING DIAGRAMWARNINGTo avoid risk of electrical shock, personal injury or death; disconnect power to dryer before servicing, unless t

Strany 5

2ERROR ITEMS AND DIAGNOSTIC CODESAn occurrence of an Error will make a sound of error melody for 5sec and continuously show one of the Error Displays

Strany 6

3TEST MODEService Mode (DV431 only)How to enter:- To enter Service Mode , press Mixed Load Bell + Temp. Keys 3 seconds in normal mode until it sends

Strany 7

4Continuous Run ModeHow to enter:- Press Mixed Load Bell +Dry Level(DV431) or Wrinkle Prevent + Time(DV231) for 7 sec during Power On State (normal u

Strany 8

5TROUBLE DIAGNOSIS- As the micom dry machine is congured of the complicate structure, there might be the service call. Below information is prepar

Strany 9

6No Problem What To Do1 Will Not Start or Run• All wires are hooked up to their corresponding terminals.• Dryer is plugged in.• Blown fuse or circu

Strany 10 - TROUBLE SHOOTING

7No Problem What To Do8The igniter does not glowIf the igniter does not heat up, remove power and using an ohmmeter, check the following:• Open ame

Strany 11

8TROUBLE SHOOTINGWARNINGTo avoid risk of electrical shock, personal injury or death; disconnect power to dryer before servicing, unless testing requir

Strany 12 - WIRING DIAGRAM

9GAS MODELTROUBLE SHOOTINGWARNINGTo avoid risk of electrical shock, personal injury or death; disconnect power to dryer before servicing, unless testi