3-20
E
3-19
■
Move the SCC-C6475(P) setup mode to the Basic Configuration ➞ IP page.
■
Assign IP Type as ‘Dynamic IP’ in the Connection Configuration item, if the
user uses SCC-C6475(P) by connecting the ADSL modem, assign
Connection type as ‘ADSL Modem’. If the user uses SCC-C6475(P) by
connecting the Cable modem, assign the Connection type as ‘Cable
Modem’.
●
Be aware if the Connection Configuration item is not set properly to
the user’s network environment, the access cannot be done or the
image cannot be appeared smoothly.
■
If the user uses SCC-C6475(P) by connecting ADSL Modem, enter the
ADSL access ID and Password that ISP has provided in the ADSL
Configuration item.
■
If the user click the Apply button, the message to terminate the internet
browser and reboot the camera will be appeared.
■
After powering off the SCC-C6475(P), separate the PC and the
camera connected to Cross Ethernet cable, and connect the camera to
the network line of ADSL or Cable.
■
And then powering on, the camera will operate as ADSL/Cable Modem
mode and receive to operate a new IP from the ADSL/Cable ISP.
●
ADSL / Cable modem can be delayed or failed as the ISP
condition. In case of this, ON/OFF the modem and wait for
about 1 minute after powering off SCC-C6475(P) and then
power on again.
■
This new ADSL/Cable IP is registered in the DDNS server.
■
User can monitor the image to access the camera after entering the
DDNS address (Example: cfffe42.websamsung.net) in the Remote PC
internet browser.
●
Depends on the ISP condition, the ADSL/Cable IP registered in
DDNS can be delayed to access, wait for about 1~2 minutes
and retry to access if the access fails in the beginning.
■
DDNS Address is composed of 6 figures at the end of SCC-C6475(P)
MAC Address, Alphabet 'c', and the combination of domain name
“websamsung.net”.
Example) If the MAC Address of SCC-C6475(P) is 00:00:f0:ff:fe:42,
DDNS Address = c + fffe42 + websamsung.net =
cfffe42.websamsung.net
Komentáře k této Příručce