Samsung DC48GTTX Uživatelský manuál stáhnout pdf (Strana 12)

E-12

Connecting the cable (Continued)

Wiring Diagram of Connection Cord

 When connecting cables, you can connect the cables to the electrical part or

connect them through the holes below depending on the spot.



When connecting cables, make the cable pass through the cable tube

as shown at the figure.

Cable tube

Connection cord

Communication cable

Power cable

 Must keep the cable in a protection tube.



Keep distances of 50mm or more between power cable and communication cable.

When the cables are connected through the hole, remove the Plate bottom.

CAUTION

Connecting the Power Terminal



Connect the cables to the terminal board using the compressed ring terminal.



Connect the rated cables only.



Connect using a driver which is able to apply the rated torque to the screws.



If the terminal is loose, fire may occur caused by arc.

If the terminal is connected too firmly, the terminal may be damaged.

Tightening Torque (kgf • cm)

5.9 1 phase 220V

30.0 3 phase 380V

Note Ground wire for the indoor unit and outdoor unit connection

cable must be clamped to a soft

copper tin-plated eyelet terminal with M4 screw hole(NOT

SUPPLIED WITH UNIT ACCESSORIES).

1(L)

2(N)

(C)

Vc Vc

L1 L2 L3 N

1�L) 2(N) 3(C)

Indoor Unit

Outdoor Unit

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Žádné komentáře

Samsung DC48GTTX Uživatelský manuál Strana 12