
4-65
Chapter 4 Diagnosis Modes
Single Static Line
Used to examine the sectional image at an angle perpendicular to the default line shown on the
image. Use the soft menu’s dial-button [2] to rotate the default line.
Dynamic Line
Used to examine the sectional image at an angle perpendicular to a line drawn by the user.
X
Draw a line by using the trackball and the Set button. The starting point is marked with an S and
the end point with an E.
X
To change the line’s angle, use the soft menu’s dial-button [2] Rotate Line.
Contour
Used to examine the sectional image at an angle perpendicular to a line or curve contoured by the
user. Instructions for contouring, moving, and adjusting the line are the same as with Dynamic Line.
Multi Line
Used to examine the sectional image at an angle perpendicular to a line drawn by the user. Instructions
for drawing, moving, and adjusting the lines are the same as with Dynamic Line.
NOTE: With Multi Line and Multi Contour, you can only draw two or more lines if Auto Increase
has been turned on.
Multi Contour
Used to examine the sectional image at an angle perpendicular to a line or curve contoured by the
user. Instructions for contouring, moving, and adjusting the line are the same as with Dynamic Line.
Komentáře k této Příručce