
U Refill Toner Ltd., 305 Telsen Centre, Thomas Street, Birmingham, B6 4TN, United Kingdom
Telephone UK 0121 448 3561 http://www.urefilltoner.co.uk
3
Waste
The cartridge collects waste toner in a compartment which, in theory, could fill up completely and
cause print problems.
In practice, we found that the waste is unlikely to fill up before the end of 3 refills (which is the
maximum possible unless compatible chips become available). Based on experience with comparable
cartridge designs, we think 5 refills should be possible with no waste worries. To future-proof this
document, we’re including full information about the waste and how to empty it if you want to go
down that road.
The symptom of waste overflow is black “skid marks” down one side of the page (usually, but not
always, the left side). If you seem to have that, try following these steps to empty the waste.
How to empty the waste
You need a vacuum with the “hairy” attachment on. Only use the vacuum near a toner cartridge
with the hairy attachment on and only use for cleaning stray toner powder, not for sucking up the
bulk of any big piles of toner.
1. Undo 2 screws.
2. Hold cartridge upside
down as shown, unhinge
and separate waste
collector unit.
3. Hold slit upwards to keep waste in.
4. Shake out waste from waste unit straight into outside bin.
5. Applying virtually no pressure, clean up inner surface of waste
collector surfaces of waste unit by vacuuming with hairy
vacuum attachment. Take care not to damage delicate catcher
blade.
6. Vacuum off outside surface of waste collector.
7. Re-hinge the waste section and replace the two screws.
UK 0121 448 3561
UK 0121 448 3561
UK 0121 448 3561
Komentáře k této Příručce