Samsung WF457ARGSGR/A2 Příručka a uživatelská příručka Strana 66

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 240
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 65
66_ Troubleshooting
Troubleshooting
ERROR CODE MEANING & SOLUTION

The Water Level sensor is not working properly.
Contact customer service.
The washer will stop operating temporarily until the water is completely
drained.
It takes a maximum of 3 minutes for the water to drain completely.

A jammed key.
Contact customer service.

A temperature sensor problem.
Restart the cycle. If the code reappears, contact customer service.

A motor problem.
Restart the cycle. If the code reappears, contact customer service.

High/Low voltage detected.
Restart the cycle. If the code reappears, contact customer service.

A communication error between the SUB PBA and the MAIN PBA
Contact customer service.

A communication error between the Wi-Fi Module and the MAIN PBA
Contact customer service.

A communication error between the DR MODEM and the MAIN PBA
Contact customer service.

A communication error between the LCD Module and the MAIN PBA
Contact customer service.

A MEMS sensor problem.
Contact customer service.



A system error
Contact customer service.

Too many suds are detected during the wash session. The unit is put on hold until
the amount of suds have been reduced. The unit will then go back to operating.
When it finishes washing, the “End” and “SUdS” codes will blink in turn.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
WF457ARG-03153A-09_EN.indd 66 2014/4/30 15:17:50
Zobrazit stránku 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 239 240

Komentáře k této Příručce

Žádné komentáře