Samsung AS18A9(A0)RCD Instalační manuál stáhnout pdf (Strana 16)

INSTALLATION

(TEFLON tape is strongly recommended around threads to help prevent leakage)

CHECK

VALVE

ADAPTOR

※Check for any water leaks.

Intallation Base

1. Put the 2 Bolts into the 2 Installed Bolt Cases

2. Place this Bolt assembly into the Installation

Base as shown.

3. Guide Arrows on the Installation Base should

face up and towards the Toilet Tank.

4. Place the Installation Base and guide the Bolts

into the 2 holes on the toilet bowl.

1. Slide the seat onto the installation Base centering

the unit with the guide arrows on the Base.

2. You will hear a click once the seat is securely

mounted to the Installation Base.

3. The seat will feel a little loose on the toilet bowl.

Adjust the fit from front to back and side to side for balance.

4. Tighten the nuts on both bolts securely.

1. Connect the flexible tube from male-male

Adaptor to the seat.

2. Open the water valve.

3. Check for leaks.

4. If there are no leaks and the surrounding

area is clean and dry, connect the power

cord to a ground protected power outlet.

Fit the cone packing and plastic washers onto

the bolts from below the toilet bowl as shown.

2. Loosely tighten nuts by hand.

Installation Base Assembly. Bolt and Nut Assembly.

Bio Bidet Shower Toilet Seat Assembly. Water Supply Tube Assembly.

Cone Packing

Washer

Nut

Installation Manual and Operating Instructions

Bolt Case

Bolt

ELECTRONIC BIDET TOILET SEAT

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Žádné komentáře

Samsung AS18A9(A0)RCD Instalační manuál Strana 16