Samsung SP-350 Specifikace stáhnout pdf (Strana 20)

6.9 5.5 4.1 9.2 30.1

7.1 5.7 4.3 9.6 31.4

7.4 5.9 4.4 9.9 32.4

7.6 6.1 4.6 10.2 33.4

2. Select one from Front-Floor, Front-Ceiling, Rear-Floor and Rear-Ceiling according to the location to install the projector.

3. Set the values of the H-Keystone and the V-Keystone to '0' and place the zoom knob right in the middle of its movement range.

4. Press the MENU button to display the Crosshatch screen of the Test Pattern.

(Setup → Test Pattern → Crosshatch)

5. Adjust the location of the projector until lines ① and ② in the picture below become parallel.

Screen Crosshatch Test Pattern

① A virtual vertical line made on the screen using a piece

of thread, etc.

② A vertical line in the middle of the Test Pattern

6. Adjust the projector's angle so that a corner of the projected picture (which is nearest to the projector) meets that of the screen.

: Projector

B : Screen

C : Projected image

D : A corner of the picture nearest to

the projector

→

Adjust the projector's angle until the projected image covers the entire screen area

(The projected image may not cover the entire screen area depending on the projector's installation height. In this case, adjust the

projector's angle so that the entire screen area can be covered.)

7. Press the V.KEY-STONE button on the remote control. The V-Keystone menu will be displayed.

Adjust V-Keystone using the + or - button on the remote control.

- A : Projector - B : Screen - C : Projected image

Downloaded From projector-manual.com Samsung Manuals

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 42 43

Žádné komentáře

Samsung SP-350 Specifikace Strana 20